Плата датчика КСВ/мощности DCMAX-1K V2 с интерфейсом DigiAmp

Описание

Directional coupler with SWR and POWER sensor, coupled with DIGIMAX interface to make it possible to read voltage, current (requires installation of INA202IC) and temperature. It can be used from low VHF band all the way up to high VHF and higher. Excellent for FM radio, DAB+ digital radio and VHF TV.

Please note this unit is not a filter, it is just sensor board with a number of protections (SWR, overload, over-current, temperature).

Этот продукт можно использовать с нашими FM-возбудителями: MAXPRO6015, MAXPRO7015, MAXPRO8015 а так же наши новые ТВ возбудители (ТВМАКС6000). Также поддерживается нашим Универсальная плата управления усилителем.

Технические характеристики:
- Входное/выходное сопротивление: 50 Ом
– Вносимые потери: 0,1 дБ тип.
– Power handling: > 1000W @ FM band
– датчик КСВ
- Датчик мощности
– Input/output connectors: solder pads for coax, RG-142 or other PTFE is recommended
– Power limit trimmer (works with our exciters via DIGIAMP but can also pull down bias voltage)
– SWR limit trimmer (works with our exciters via DIGIAMP but can also pull down bias voltage)
– Current limit trimmer (works with our exciters via DIGIAMP but can also pull down bias voltage, this requires installation of extra IC and trimmer capacitor)
– Size: 40x85mm, PTFE board

About protections:
This board can protect against:
– High SWR (it can pull bias down or reduce drive via exciter – exciter must support DigiAmp)
– High Temp (it can reduce drive via exciter – exciter must support DigiAmp)
– High Current consumption (it can pull bias down or reduce drive via exciter – exciter must support DigiAmp)
– Excesive output from too much drive (it can pull bias down or reduce drive via exciter – exciter must support DigiAmp)

Что включено:
– плата DCMAX-1, 1 шт.
– 10K NTC temperature sensor (M3 screw mounts to heatsink)

– DigiAmp cable with connectors is НЕТ included and can be ordered separately
– Current sensor IC (INA202AIDGKT) is НЕТ installed, it was not possible to buy these at the time of manufacturing. If you want to install current sensor please solder this IC and also missing 10K SMD trimmer.