Diana needs help about NCS2001 amp

This is the place where you can ask questions
related to schematics posted on our website
and request new schematics. We will try to post whatever is possible.

Moderators: Sir Nigel, Nina, pcs, 5r, phpBB2 - Administrators

Post Reply
Diana
New registered user
New registered user
Posts: 1
Joined: Sat Jun 05, 2004 8:45 pm

Diana needs help about NCS2001 amp

Post by Diana »

Hello,
Can anyone help me on my little project herein. I'm using an rail-to-rail operational sub-1V amplifier
NCS2001SQ2T1 (ON Semiconductors), for ampifying very low (mono) audio signal from an old reciever. Ampifyer is powered by single 1,4 button cell. Earphones are on output.
Since I'm still a beginer in electronics (or complete retard :), I don't know which pin on the
NCS2001SQ2T1 should I connect with bat-, bat+, ear1, ear2, input1 and input2 contacts. Because of very small gabarits needed (therefore I use button cell), it is desirable the whole circuit has as minimum aditional components (SMD resistors and capacitors) as possible, regardeles the sound quality.
No volume potentiometers also; I need maximum output power that NCS2001 can provide. Simple as that. But not for me !
Btw:Could I use 2 or 3 IC-s for aditional amplification ?
I would very apriciate a simple scetch if possible. Thx. :wink:

NCS2001 links:
http://www.onsemi.com/site/products/sum ... 01,00.html
http://www.onsemi.com/pub/Collateral/NCS2001-D.PDF (127KB)
Post Reply