PCS Electronics PCS Electronics - home page PCS Electronics  
RegisterSearchFAQAM & FM Radio transmitters shop UsergroupsLog in
Tutorial for MAX PRO I LCD

 
Reply to topic    PCS-Electronics Forum Index » Schematics - help and ideas View previous topic
View next topic
Tutorial for MAX PRO I LCD
Author Message
kresebeke
New registered user
New registered user


Joined: 13 May 2004
Posts: 2

Post Tutorial for MAX PRO I LCD Reply with quote
i bought the MAX PRO I at PCS Electronics and there are some problems with the LCD, cause i can´t change the frequency no more. i don´t have any kind of tutorial about the configuration of the LCD or how can i work with it. I tried to send some e-mails to PCS but until now nothing. Could someone explain to me how can i work with it?

thanks


marcelo
Thu May 13, 2004 12:37 pm View user's profile Send private message
pcs
Site master
Site master


Joined: 18 Jan 2002
Posts: 3063
Location: Radio Land

Post Reply with quote
Where have you sent the e-mail? To our hotmail email?
That email is only used for MSN messanger. We do not
read it (as stated on the website).

If you have used the proper email, than please disable
your email filters, they are obviously blocking our email.

It is sad, but due to excess volume of spam nowadays people
use filters. Sometimes these filters block valid email. That makes
it impossible to contact them.

It happens every 1-3 days, actually, so it is a big problem.

What's even more frustrating is that people mistype their email
or have their reply-to email setup incorrectly.

If you haven't received any response in more than 3-4 days,
please resend your email from another email account and make sure
your spam filters are not set too agresively!

I remember a customer who asked for instructions for MAX 1
and the email bounced.

If you're getting "Error" on the LCD when you try to change
frequency, please connect pins 7 and 4 on the 24Cxx chip
with a short piece of wire (or any resistor you have at hand,
the exact value is not important).

This happened sometimes on the old LCD boards due to eeprom
not performing as specified in datasheet.

_________________
Best regards,
Marko - PCS Electronics
--------------------------------------------------------
Turn your PC into a FM radio station!
http://www.pcs-electronics.com
fax +386 4 2316 128
Thu May 13, 2004 4:21 pm View user's profile Send private message Visit poster's website
Display posts from previous:    
Reply to topic    PCS-Electronics Forum Index » Schematics - help and ideas All times are GMT + 1 Hour
Page 1 of 1

 
Jump to: 
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group