auggested settings for cybermax 1kw (attack, threshold, etc

Discussions regarding our FM transmitters, DX reports, antenna designs, problems...

Moderators: Sir Nigel, Nina, pcs, 5r, phpBB2 - Administrators

Post Reply
radycal
New registered user
New registered user
Posts: 3
Joined: Wed Jun 19, 2013 4:27 am

auggested settings for cybermax 1kw (attack, threshold, etc

Post by radycal »

looking for suggested audio settings ----- attack - threshold - etc. The system defaults are a little lacking in audio quality in my opinion .... anyone had some settings they are happy with (can't afford an orban yet). Playing HOT AC. I put a compressor limiter in line but still can't seem to compensate for what comes out of the transmitter (lots of esss sounds). Backed off treble on trans. -3 but afraid to turn it down even further.
User avatar
pcs
Site master
Site master
Posts: 3132
Joined: Fri Jan 18, 2002 1:00 am
Location: Radio Land
Contact:

Post by pcs »

The default should work pretty good, but for real punch you should look at the pro audio processing units:
http://www.pcs-electronics.com/studio-e ... 68_83.html

The 4-band is sweet spot, not as expensive as the 6-band but giving plenty punch.

There are also some DSP software solutions for your PC, SAM broadcaster has a very good DSP processor engine.

If you use any of these, pull the EQ after 15KHz down. Should help.
Best regards,
Marko - PCS Electronics
--------------------------------------------------------
Turn your PC into a FM radio station!
http://www.pcs-electronics.com
fax +386 4 2316 128
Post Reply