PCS Electronics PCS Electronics - home page PCS Electronics  
RegisterSearchFAQAM & FM Radio transmitters shop UsergroupsLog in
How do I use the Ethernet card?

 
Reply to topic    PCS-Electronics Forum Index » FM transmitters View previous topic
View next topic
How do I use the Ethernet card?
Author Message
davidcr
New registered user
New registered user


Joined: 11 Sep 2013
Posts: 1

Post How do I use the Ethernet card? Reply with quote
hi. I came to a station that uses a MAXPRO 3000 card as exciter, an RS232 serial port and also have an additional network card.

RS232 interface is connected to the LCD module, I understand that the network card is connected to the same terminal of the LCD module, and red wire at power suppy 12V and ground. The LED on the network card power on... and then? what else should I do?

How to specify an IP? What software do I use to control the transmitter?


Thanks.
Wed Sep 11, 2013 9:20 pm View user's profile Send private message
pcs
Site master
Site master


Joined: 18 Jan 2002
Posts: 3063
Location: Radio Land

Post Reply with quote
Hi,

I suggest you check the manual for the MAX PRO 5015, the MAX PRO 3000 is an older product and at the time Ethernet module did not exist yet.

Yes, the red wire goes to +12V. The 5 pins go to the 5 pins on the LCD.

Let me know if you get stuck.

_________________
Best regards,
Marko - PCS Electronics
--------------------------------------------------------
Turn your PC into a FM radio station!
http://www.pcs-electronics.com
fax +386 4 2316 128
Mon Sep 16, 2013 12:01 am View user's profile Send private message Visit poster's website
Display posts from previous:    
Reply to topic    PCS-Electronics Forum Index » FM transmitters All times are GMT + 1 Hour
Page 1 of 1

 
Jump to: 
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group