PCS Electronics PCS Electronics - home page PCS Electronics  
RegisterSearchFAQAM & FM Radio transmitters shop UsergroupsLog in
aluminum adhesive backed tape to seal the RF from escaping

 
Reply to topic    PCS-Electronics Forum Index » Improvement and suggestions View previous topic
View next topic
aluminum adhesive backed tape to seal the RF from escaping
Author Message
stylzmovement
Compulsive poster:)
Compulsive poster:)


Joined: 11 Oct 2003
Posts: 142

us.gif

Post aluminum adhesive backed tape to seal the RF from escaping Reply with quote
hi,
a few months ago , i ask a question about the number of screws in your transmitters, i have an enclosure from another manufacturer there are only 4 screws on the top and bottom of the unit , can i use aluminum adhesive backed tape to seal the RF from escaping?
Tue May 20, 2008 12:10 pm View user's profile Send private message
pcs
Site master
Site master


Joined: 18 Jan 2002
Posts: 3063
Location: Radio Land

Post Reply with quote
You can, but there is no real need for that.

It may be usefull in environment where you have lots and lots of transmitters/receivers
in one room, such as in a radio tower with tv/radio transmitters.

In a single unit installation or small installation its not needed and there will be no
noticeable difference.

_________________
Best regards,
Marko - PCS Electronics
--------------------------------------------------------
Turn your PC into a FM radio station!
http://www.pcs-electronics.com
fax +386 4 2316 128
Tue May 20, 2008 2:48 pm View user's profile Send private message Visit poster's website
Display posts from previous:    
Reply to topic    PCS-Electronics Forum Index » Improvement and suggestions All times are GMT + 1 Hour
Page 1 of 1

 
Jump to: 
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group