i will like to build an amplifier using a drive exciter ( max pro 3 ) into a 2 or 3 ways splitter to power two or three amp modules, do you have these spliters on the site?
will i need any additional devices?
RF two or 3 ways Splitters
Moderators: Sir Nigel, Nina, pcs, 5r, phpBB2 - Administrators
- stylzmovement
- Compulsive poster:)
- Posts: 142
- Joined: Sat Oct 11, 2003 8:59 pm
Yep, you missed this one I think:
http://www.pcs-electronics.com/transmit ... 1_102.html
Typically it is done in x2 mode, meaning you'll need 2 or 4 pallets.
You need equal pallets (same type) for this as the full amp with filters
differs too much from another one, even if of the same type.
Phase shift in LC filter makes it impossible to combine/splits signals across
the band.
Here is a complete kit for you:
http://www.pcs-electronics.com/1500w-am ... -1237.html
It lacks 1500W filter only.
If you get stuck ask before burning expensive pallets
http://www.pcs-electronics.com/transmit ... 1_102.html
Typically it is done in x2 mode, meaning you'll need 2 or 4 pallets.
You need equal pallets (same type) for this as the full amp with filters
differs too much from another one, even if of the same type.
Phase shift in LC filter makes it impossible to combine/splits signals across
the band.
Here is a complete kit for you:
http://www.pcs-electronics.com/1500w-am ... -1237.html
It lacks 1500W filter only.
If you get stuck ask before burning expensive pallets
Best regards,
Marko - PCS Electronics
--------------------------------------------------------
Turn your PC into a FM radio station!
http://www.pcs-electronics.com
fax +386 4 2316 128
Marko - PCS Electronics
--------------------------------------------------------
Turn your PC into a FM radio station!
http://www.pcs-electronics.com
fax +386 4 2316 128