How to Test a Transmitter's Power Output?

Discussions regarding our FM transmitters, DX reports, antenna designs, problems...

Moderators: Sir Nigel, Nina, pcs, 5r, phpBB2 - Administrators

Post Reply
endgame
New registered user
New registered user
Posts: 6
Joined: Wed Sep 19, 2007 1:05 pm

How to Test a Transmitter's Power Output?

Post by endgame »

How to Test a Transmitter's Power Output?
User avatar
pcs
Site master
Site master
Posts: 3132
Joined: Fri Jan 18, 2002 1:00 am
Location: Radio Land
Contact:

Post by pcs »

By using SWR/POWER meter. Best done into dummy load as antenna may not be
a perfect match and power meter often does not show correct value under such
conditions.
Best regards,
Marko - PCS Electronics
--------------------------------------------------------
Turn your PC into a FM radio station!
http://www.pcs-electronics.com
fax +386 4 2316 128
User avatar
nay27uk
Regular poster
Regular poster
Posts: 29
Joined: Mon Jun 08, 2009 11:01 am
Contact:

Post by nay27uk »

marko is ther anyway of doing this with a volt meter, was just wondering as i have had lots of troble tuning my VFO home built transmitter. I would get it so i thought it was on the proper frequency (or at least it sounded like it in the house) when i went for a walk 500 yards away the transmision is on another frequency.

Anyway i managed to get the frequency i wanted but could only recive it for around 1 mile, so i knew it was somthing to do with either SWR or output power, so i went back home determined to get the thing out further and being as tho i had no power meter or swr meter i had a bright idea of using a volt meter on the antenna and final, in the end the black - lead of the volt meter was resting on the earth of the SO239 with the antenna conected, and the red lead of the volt meter was resting on the emiter of the 2SC1971 transister that is also conected to earth, then using the three 40pF variable capacitores in the final stage i tuned them finely untill i got the highest volts reading i could with the meter set to 200VDC the final and highest reading i could get was 03.50V or 3.5 volts if you like.

After doing this i went for a walk and hey presto the transmition halted at 4 miles because of another stronger station.

So back to my question is ther anyway of tuning a transmitter using only a volt meter, it seems to have helped me, but did i do it right, is ther another way of doing it using a volt meter
User avatar
pcs
Site master
Site master
Posts: 3132
Joined: Fri Jan 18, 2002 1:00 am
Location: Radio Land
Contact:

Post by pcs »

You could do something like this:
http://www.ab4oj.com/pwrmeas.html

Calibrating this versus a real power meter
would be nice.

I think a swr/power meter is something you'll
need sooner or later so why not invest in one.

If nothing else to tune antenna.
Best regards,
Marko - PCS Electronics
--------------------------------------------------------
Turn your PC into a FM radio station!
http://www.pcs-electronics.com
fax +386 4 2316 128
User avatar
nay27uk
Regular poster
Regular poster
Posts: 29
Joined: Mon Jun 08, 2009 11:01 am
Contact:

Post by nay27uk »

thank you pal
Post Reply