PCS Electronics PCS Electronics - home page PCS Electronics  
RegisterSearchFAQAM & FM Radio transmitters shop UsergroupsLog in
New product: New filter added to product portfolio

Reply to topic    PCS-Electronics Forum Index » FM transmitters View previous topic
View next topic
New product: New filter added to product portfolio
Author Message
Site master
Site master

Joined: 18 Jan 2002
Posts: 3122
Location: Radio Land

Post New product: New filter added to product portfolio Reply with quote

500-1000W Low Pass filter with built-in SWR/Power meter Most FM transmitters produce harmonics at even multiples of your fundamental frequency. If your harmonics fall on or near a TV channel or Maritime frequency you could cause severe interference to that channel. The most common cause of fines from federal agencies is due to TVI or other interference from your transmitter which generates a complaint. Use of the nicely priced PCS 3000 low pass filter is the best method of eliminating this kind of interference. The low insertion loss of the PCS-3000 filters makes them well suited for use on power levels as low as 10 watts on up to 500-1000 watts!

These units are constructed using high-quality 1KV mica capacitors and silver-plated wire! SWR and PWR voltages are provided for power/swr measuring purpose. Two calibrating trimmers are provided as well to simplify operation. SWR protection circuitry is provided as well and its sensitivity can be adjusted with one of the trimmers. When reflected power (SWR) reaches certain level swr protection output goes low and pulls more current low as the reflected power increases. This can be connected to the bias circuitry in your amplifier to shut-down the power and prevent damage to the output transistors.

Available in two versions, one without any coaxial cable included and the other with two 15-cm pieces of high quality teflon hi-temp coaxial cable, fully stripped on both ends and soldered to the PCB on one end. Feel free to order any connectors with this version and we will solder/attach them to the cable for you, just ask for this service under comments at checkout.

A perfect companion for the pallet amplifiers, offering output filtering and swr protection! Also allows cascading for ultra clean signal!

Technical specifications:
- Input/Output Impedance: 50 Ohms
- Insertion Loss: 0.3dB typ.
- Power handling: 500W tested, should handle 1KW easily
- Typical stop-band attenuation: >40dB
- Cut-Off Frequency: 120 MHz (-3dB down)
- Input/Output Connectors:solder pads for coax
- Duty Cycle Rated for continuous operation

Best regards,
Marko - PCS Electronics
Turn your PC into a FM radio station!
fax +386 4 2316 128
Wed May 02, 2007 3:28 pm View user's profile Send private message Visit poster's website
Display posts from previous:    
Reply to topic    PCS-Electronics Forum Index » FM transmitters All times are GMT + 1 Hour
Page 1 of 1

Jump to: 
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum

Powered by phpBB © 2001, 2005 phpBB Group