MAX PRO 3

Discussions regarding our FM transmitters, DX reports, antenna designs, problems...

Moderators: Sir Nigel, Nina, pcs, 5r, phpBB2 - Administrators

Post Reply
BDC
New registered user
New registered user
Posts: 10
Joined: Fri Feb 10, 2006 1:48 am
Location: Vietnam

MAX PRO 3

Post by BDC »

Dear sir,
We have a Max pro 3 working well on 5-6 years. Now we have a problem of frequency. We set it 91.7 MHz, but the transmitter actually working on 90.8 MHz, about 1MHz lower. Can we now adjust it somehow.
Thank you and best regards.
User avatar
pcs
Site master
Site master
Posts: 3132
Joined: Fri Jan 18, 2002 1:00 am
Location: Radio Land
Contact:

Post by pcs »

Its probably more than 5-6 years as we haven't sold these for more than that.

The new MAX PRO 3000 and especially 5015 are much better.

You can send your old unit here for a check, I will be happy to check it out for you inexpensively, for old times sake.
Best regards,
Marko - PCS Electronics
--------------------------------------------------------
Turn your PC into a FM radio station!
http://www.pcs-electronics.com
fax +386 4 2316 128
BDC
New registered user
New registered user
Posts: 10
Joined: Fri Feb 10, 2006 1:48 am
Location: Vietnam

Post by BDC »

Thank you for your reply. It is expennsive to send the kit back to you althought you will check inexpensively for us. Can you gve us some orther advices?
Thanks.
User avatar
pcs
Site master
Site master
Posts: 3132
Joined: Fri Jan 18, 2002 1:00 am
Location: Radio Land
Contact:

Post by pcs »

Hi,

actually since we have a special on MAX PRO 2000 it may be cheaper to just get this new exciter.

As for the service it is hard to say after all these years, possibly a deteriorated solder joint somewhere.
Just like you have to go see a doctor to get prognosis you also have to send your unit to us to heal it :)
Best regards,
Marko - PCS Electronics
--------------------------------------------------------
Turn your PC into a FM radio station!
http://www.pcs-electronics.com
fax +386 4 2316 128
Post Reply