CYBER MAX MICRO+ MPX INPUT
Moderators: Sir Nigel, Nina, pcs, 5r, phpBB2 - Administrators
CYBER MAX MICRO+ MPX INPUT
On the CYBER MAX MICRO+ transmitters page it states "MPX input can be added easily" How would I be able to bypass the built in stereo encoder and connect the MPX output of my SE5000 DSP+ stereo encoder to this transmitter? Thanks, Steve
There are several pins provided for plugging in the RDS daughter board.
One of these is MPX in. You can inject your audio here via 1K resistor for example.
One of these is MPX in. You can inject your audio here via 1K resistor for example.
Best regards,
Marko - PCS Electronics
--------------------------------------------------------
Turn your PC into a FM radio station!
http://www.pcs-electronics.com
fax +386 4 2316 128
Marko - PCS Electronics
--------------------------------------------------------
Turn your PC into a FM radio station!
http://www.pcs-electronics.com
fax +386 4 2316 128
CYBER MAX MICRO+ MPX INPUT
HI, Thanks for your help. could you tell me which pin is the mpx input so I don't blow anything out? And will doing this mix the external mpx signal im adding to the internal stereo encoders mpx signal or disable the internal mpx signal? thanks for your help, steve
It will mix it in so make sure to set board to Mono when you do this.
Look for 3 pins marked GND, +5V and +9V.
Further below are three unmarked pins.
The one at the bottom is MPX in.
Look for 3 pins marked GND, +5V and +9V.
Further below are three unmarked pins.
The one at the bottom is MPX in.
Best regards,
Marko - PCS Electronics
--------------------------------------------------------
Turn your PC into a FM radio station!
http://www.pcs-electronics.com
fax +386 4 2316 128
Marko - PCS Electronics
--------------------------------------------------------
Turn your PC into a FM radio station!
http://www.pcs-electronics.com
fax +386 4 2316 128