Cooling the amp

Discussions regarding our FM transmitters, DX reports, antenna designs, problems...

Moderators: Sir Nigel, Nina, pcs, 5r, phpBB2 - Administrators

Post Reply
User avatar
stylzmovement
Compulsive poster:)
Compulsive poster:)
Posts: 142
Joined: Sat Oct 11, 2003 8:59 pm

Cooling the amp

Post by stylzmovement »

is it better to pull the hot air out the enclousure?
of is it better to blow the cool air over the heatsink and into the elclousure?
User avatar
cliffyk
Regular poster
Regular poster
Posts: 43
Joined: Wed Sep 28, 2005 10:06 pm
Location: 87.9 to 107.9
Contact:

Post by cliffyk »

Hot air out, preferably with the heatsink located somewhere in the airflow's general path--unless...

You have a good way of directing the flow of air you are pushing in.

In my MaxPro I rackmount enclosure I have two 40 mm fans at the rear of the enclosure and perforations on the side next to the exciter.

The airflow is more or less as depicted by the yellow arrow, there are also perforations in the top cover over the power supply so that air is drawn in and down through the p/s as well.
-cliff knight-
My Miata
User avatar
pcs
Site master
Site master
Posts: 3132
Joined: Fri Jan 18, 2002 1:00 am
Location: Radio Land
Contact:

Post by pcs »

With high power units I prefer to have fan blow directly into the hot spot.

When sucking (sounds nasty, hehe) you get less control where the airflow is going. Or is this just my
subjective thinking?
Best regards,
Marko - PCS Electronics
--------------------------------------------------------
Turn your PC into a FM radio station!
http://www.pcs-electronics.com
fax +386 4 2316 128
User avatar
cliffyk
Regular poster
Regular poster
Posts: 43
Joined: Wed Sep 28, 2005 10:06 pm
Location: 87.9 to 107.9
Contact:

Post by cliffyk »

When dealing with a heat generating sources within an enclosure I tend to prefer to pull the heat out, with make up air being delivered through strategically placed louvers/perforations/etc. I don't know that it makes any difference with the levels of heat we're talking about here, however the basic goal with enclosures remains to get the heat out.

With larger industrial cabinets we were taught that "blowing" pushes the heat generated by the fan drive into the cabinet, but that "sucking" discharges the fan drive heat directly.
Last edited by cliffyk on Fri Aug 04, 2006 12:40 am, edited 1 time in total.
-cliff knight-
My Miata
User avatar
pcs
Site master
Site master
Posts: 3132
Joined: Fri Jan 18, 2002 1:00 am
Location: Radio Land
Contact:

Post by pcs »

Good point.
Best regards,
Marko - PCS Electronics
--------------------------------------------------------
Turn your PC into a FM radio station!
http://www.pcs-electronics.com
fax +386 4 2316 128
Post Reply