Output power of PCI MAX 2006
Moderators: Sir Nigel, Nina, pcs, 5r, phpBB2 - Administrators
Output power of PCI MAX 2006
I have measured output power my PCI MAX 2006 by wattmeter Telewave 44A. I could see a maximum only 0.5 W. Transmitter is being used as separate unit with DC power supply 12 V 20 A. Measuring have been done with equivalent load 50 ohm. Anybody can explain this strange result?
Technical specifications of PCI MAX 2006 tell about 15 V maximum. I have one's doubts that output power will increase till 1W from addition 3 volts powering. But I'll test it of course. Did anybody measure output power PCI MAX?Sir Nigel wrote:That's not really strange you just don't seem to have enough volts powering it. I'm not sure what its limit is, but I would think it can go higher.
installed hardware AND external power supply?
Hello,
I got my PCIMAX Pro 2006+ (1W) a few days ago. I installed it with the 2005 driver (2006 doesn't work). My problem is, that the range is very bad (~ 50-100 meter) I've read a lot of posts in the forum about external power supply for full output power.
Now my question: Can I simply connect stabile 12V although the card is installed in the computer? I'm afraid of disturbing my card or computer..
excuse my english
regards, addy
I got my PCIMAX Pro 2006+ (1W) a few days ago. I installed it with the 2005 driver (2006 doesn't work). My problem is, that the range is very bad (~ 50-100 meter) I've read a lot of posts in the forum about external power supply for full output power.
Now my question: Can I simply connect stabile 12V although the card is installed in the computer? I'm afraid of disturbing my card or computer..
excuse my english
regards, addy
Yep, that is exactly what you must do. 12V should be enough.
The PCI MAX 2006+ card is designed to limit output power when there is no external power supply.
There is a tiny switch inside which engages full power when external power supply is detected.
This was done to increase Signal/Noise ratio and protect PCI bus from excessive power draw.
It was done for your own good, in short.
The PCI MAX 2006+ card is designed to limit output power when there is no external power supply.
There is a tiny switch inside which engages full power when external power supply is detected.
This was done to increase Signal/Noise ratio and protect PCI bus from excessive power draw.
It was done for your own good, in short.
Best regards,
Marko - PCS Electronics
--------------------------------------------------------
Turn your PC into a FM radio station!
http://www.pcs-electronics.com
fax +386 4 2316 128
Marko - PCS Electronics
--------------------------------------------------------
Turn your PC into a FM radio station!
http://www.pcs-electronics.com
fax +386 4 2316 128