Coax for Amp Palet

Discussions regarding our FM transmitters, DX reports, antenna designs, problems...

Moderators: Sir Nigel, Nina, pcs, 5r, phpBB2 - Administrators

Post Reply
User avatar
stylzmovement
Compulsive poster:)
Compulsive poster:)
Posts: 142
Joined: Sat Oct 11, 2003 8:59 pm

Coax for Amp Palet

Post by stylzmovement »

I will like to know if you guys can recommend a coax cable in the RG58 family or any other to use from the 300watts and 700 watts amplifier module final stage to the connector , I am using N type panel mount connector as an outout , it is not possible to have direct solder on my project due to space limitation.
User avatar
pcs
Site master
Site master
Posts: 3132
Joined: Fri Jan 18, 2002 1:00 am
Location: Radio Land
Contact:

Post by pcs »

Normally a coax is soldered directly to the palet. rg58 is ok here since
it is a small distance.
Best regards,
Marko - PCS Electronics
--------------------------------------------------------
Turn your PC into a FM radio station!
http://www.pcs-electronics.com
fax +386 4 2316 128
Post Reply