Hi there,
Still just wondering if someone can explain adjusting the output power on my PCIMAX. That is, when i adjust the slider i don't perceive any difference at all. Shouldn't i be able to hear some difference?
Also, i bought a simple pair of rabbit ears to improve reception a bit, but the cable is very short. I happen to have some coax to extend it with, but when i use the extension, the signal has a tone on it--a kind of wavering sound almost like a modem.
I have to put the connectors on the cable myself, so i might have screwed that up--i need to check that, but is there anything else i should try to check?
Thanks for any advice,
steve
newbie questions again: output, antenna
Moderators: Sir Nigel, Nina, pcs, 5r, phpBB2 - Administrators
Those rabit ears are for TV, right?
Best regards,
Marko - PCS Electronics
--------------------------------------------------------
Turn your PC into a FM radio station!
http://www.pcs-electronics.com
fax +386 4 2316 128
Marko - PCS Electronics
--------------------------------------------------------
Turn your PC into a FM radio station!
http://www.pcs-electronics.com
fax +386 4 2316 128
Its not an antenna for radio, but if it works for you....
Best regards,
Marko - PCS Electronics
--------------------------------------------------------
Turn your PC into a FM radio station!
http://www.pcs-electronics.com
fax +386 4 2316 128
Marko - PCS Electronics
--------------------------------------------------------
Turn your PC into a FM radio station!
http://www.pcs-electronics.com
fax +386 4 2316 128
It does seem to, but it doesn't seem to improve my reception that well. Guess that's why huh?
I thought i read about doing that somewhere here, but perhaps not. I was just looking for a frugal way to help make it easier to get reception a little further away....which leads me back to my output power question...
I thought i read about doing that somewhere here, but perhaps not. I was just looking for a frugal way to help make it easier to get reception a little further away....which leads me back to my output power question...
-steve