Well, I finally received my XLR board and am ready to hook it up to my AM Max II DSP, however I didn't find instructions or a schematic in the box to guide me in hooking it up.
It seems like I saw a schematic somewhere here on your web site but I can't seem to find it. How about sending me a link or a PDF file with the particulars.
are the cables sticking to the board or not? Not sure
as my colegue prepared this.
If they are, is XLR connector connected already?
Best regards,
Marko - PCS Electronics
--------------------------------------------------------
Turn your PC into a FM radio station! http://www.pcs-electronics.com
fax +386 4 2316 128
Best regards,
Marko - PCS Electronics
--------------------------------------------------------
Turn your PC into a FM radio station! http://www.pcs-electronics.com
fax +386 4 2316 128
My colegue will send you a photo with explanation today or tomorrow.
Best regards,
Marko - PCS Electronics
--------------------------------------------------------
Turn your PC into a FM radio station! http://www.pcs-electronics.com
fax +386 4 2316 128
Ok, a couple of questions.... Originally, this unit was to be shipped with the XLR board installed so one would assume that everything would be in there so I could easily mount the board inside the box and supply power to it.?
1. Is the unit is grounded through the stand-off and no ground wire is necessary?
2. Where on the transmitter do I get the voltage to hook to the XLR board? I assume I might rob it from where the fans get their power?
3. For the connection to the transmitter, I am guessing that I should solder the sheilded cable to the back of the RCA jack observing the polarity of the jack?
4. What purpose does the pot serve? I assume it is just a volume control to attenuate the signal?
Antler wrote:Ok, a couple of questions.... Originally, this unit was to be shipped with the XLR board installed so one would assume that everything would be in there so I could easily mount the board inside the box and supply power to it.?
1. Is the unit is grounded through the stand-off and no ground wire is necessary?
Yes
2. Where on the transmitter do I get the voltage to hook to the XLR board? I assume I might rob it from where the fans get their power?
Look at that regulator 7812. We usually take if from tap 3 of that
regulator.
3. For the connection to the transmitter, I am guessing that I should solder the sheilded cable to the back of the RCA jack observing the polarity of the jack?
Yes
4. What purpose does the pot serve? I assume it is just a volume control to attenuate the signal?
Yes, you can increase/decrease level, usually its best to set it to full.
Best regards,
Marko - PCS Electronics
--------------------------------------------------------
Turn your PC into a FM radio station! http://www.pcs-electronics.com
fax +386 4 2316 128
Best regards,
Marko - PCS Electronics
--------------------------------------------------------
Turn your PC into a FM radio station! http://www.pcs-electronics.com
fax +386 4 2316 128
Look at that regulator 7812. We usually take if from tap 3 of that
regulator.
Other than the power, I am ready to go. I don't have a picture showing where the 7812 regulator is and I don't see it on the PC board.. More info on the location of the 7812 regulator please?
A-man
PS. I haven't done much soldering over the last 10 years.. Given the changes in my eyes I guess I will have to get one of those bright light / magnifying glass "thing-es."
Best regards,
Marko - PCS Electronics
--------------------------------------------------------
Turn your PC into a FM radio station! http://www.pcs-electronics.com
fax +386 4 2316 128