PCS Electronics PCS Electronics - home page PCS Electronics  
RegisterSearchFAQAM & FM Radio transmitters shop UsergroupsLog in
SE4 DSP stereo encoder

 
Reply to topic    PCS-Electronics Forum Index » Stereo encoders View previous topic
View next topic
SE4 DSP stereo encoder
Author Message
pcs
Site master
Site master


Joined: 18 Jan 2002
Posts: 3063
Location: Radio Land

Post SE4 DSP stereo encoder Reply with quote
SE-4 DSP
PROFESSIONAL DSP STEREO ENCODER



This completely redesigned unit uses DSP to generate pilot and
process audio in ways which are very difficult or close to impossible
to do with usual analog technology. And it does all that in exceptionally
small factor - same size as SE3! It has many advantages over SE-3;
brick-wall low pass audio filter with a sharp 19KHz notch, limiter and
compressor, improved pilot generation due to DSP, stereo/mono switch
with LED indication, balanced and unbalanced audio inputs, increased
channel separation, precise preemphasis, less noise, on-board power
connector and an optional LCD display connector. Optional LCD control
unit makes it possible to set treble, bass, preemphasis and compressor
settings. SE4 can be connected to MAX PRO III via dedicated data cable
making it possible to control both units via single LCD control unit. Cost-
efficient and simple. Designed specifically as a companion for all MAX PRO
series exciters, but is also compatible with any FM exciter. All the
connectors and switches are mounted on the board so connecting this unit
requires no additional soldering. Mounting holes are compatible with SE3.
This is a perfect stereo encoder for beginners and professionals



Features:

Audio Response: 2OHz-15KHz, brickwall filtered
19KHz notch filter, >70 dB typ
Precise preemphasis, 50uS, 75uS or none
Audio Input Impedance: 600 Ohms, balanced or unbalanced
Audio Input Level: 0 dB
Distortion: <0.1%
S/N ratio: -70 dBm
Separation: >50 dB typ. (more than any receiver on the market)
Pilot Frequency: 19 KHz, DSP generated
Output Impedance: 75 Ohms
Power Requirements: 7-15VDC min / 150mA
PC Board Size: 100x65mm
Audio connectors: all RCA jacks are mounted on the board, 3-pin
jumper for XLR
Power connector: 2.1mm power socket, center +
LC MPX filter


Available here:
http://www.pcs-electronics.com/en/products.php?sub=stereo_encod#SE%204%20DSP

_________________
Best regards,
Marko - PCS Electronics
--------------------------------------------------------
Turn your PC into a FM radio station!
http://www.pcs-electronics.com
fax +386 4 2316 128
Thu Oct 21, 2004 10:14 pm View user's profile Send private message Visit poster's website
Display posts from previous:    
Reply to topic    PCS-Electronics Forum Index » Stereo encoders All times are GMT + 1 Hour
Page 1 of 1

 
Jump to: 
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group