PCS Electronics PCS Electronics - home page PCS Electronics  
RegisterSearchFAQAM & FM Radio transmitters shop UsergroupsLog in
Transmitter Componant Placement?

 
Reply to topic    PCS-Electronics Forum Index » FM transmitters View previous topic
View next topic
Transmitter Componant Placement?
Author Message
apollo
New registered user
New registered user


Joined: 20 Jun 2004
Posts: 3

Post Transmitter Componant Placement? Reply with quote
Are there any problems when installing a power amplifier (20-30w) inside the same enclosure as the exciter, limiter and stereo encoder?

Using the existing BNC connecter (Output) of the transmitter, is there an ideal length for the cable to the input of the power amplifier?

When being powered from an external power source, are any precautions necessary on the dc feedlines as far as length, isolation or placement that may interfere with the transmitter's output?

Thanks for you feedback...
Sun Jun 20, 2004 9:33 pm View user's profile Send private message
Black_Hawk
Compulsive poster:)
Compulsive poster:)


Joined: 15 Mar 2004
Posts: 112
Location: Entering The Flags...but simply an arm wielding a sword signifying power

Post SURE THERE ARE VARIOUS PRECAUTIONS THAT NEEDS TO BE OBSERVED Reply with quote
Depending on the environment..the customer and the cash flow that is available to hire my technical services ,Then you would not have to be concerned with such trivialites....If you are so knowledgeable to be able to solicit help from reading your post...then it is obvious that you know enough to realize that you need to contract my services...for a Price($$$.$$)....As i said the freebies are over and done with for everyone.

And also may i advise anyone that requires Technical Services..There is a consultational fee right off the Bat..And if the Answers require a detailed 'planation..the cost for such knowledge shall be proportionate..The actual solutions are priced at a different rate as well.

I hope that was helpfull enough.

"Walk Good"...Norman Michael Barrow..The Cockfighter
Mon Jun 21, 2004 5:06 am View user's profile Send private message
apollo
New registered user
New registered user


Joined: 20 Jun 2004
Posts: 3

Post Open Message To The PCS Forums Reply with quote
Thank you for your response to my questions!

Over the years I have been involved with many forums, whose general objective is to provide users seeking information upon like subjects, by sharing the knowledge, thus preventing the reinvention of the wheel. I have to admit that this is the rudest, most ignorant forum I have ever logged on to. I had not realized that this was some kind of private club or an employment agency for would be know it alls! I would suggest that you close this forum to the general public, obviously as a support forum it is a total loss and not worth the time and effort to attempt to join such a worthless source of information, populated by “smart a**” losers.

Thanks again for you ignorant response to my questions. I will go elsewhere! Thanks for the heads-up!
Tue Jun 22, 2004 1:03 am View user's profile Send private message
Antler
Compulsive poster:)
Compulsive poster:)


Joined: 29 May 2004
Posts: 90
Location: Somewhere between the RJAA and EHAM airports

Post Reply with quote
Quote:
smart a**” losers


One smarta** loser anyway.

Re your question. I am guessing here that if you don't go too wild on the amp by using lot of power, that it would work fine in the same enclosure. At the 20 - 30 watt level you may need to do some shielding to prevent RF feed back (which causes all kinds of problems). Shielding is pretty easy to do if you know what you are doing. (I am thinking a metal chassis inside your transmitter (ventilated, of course).

The way I see it, go ahead and try it. You don't have much to lose other than an hour or two of your time.

Regards, A-man
Tue Jun 22, 2004 4:36 am View user's profile Send private message
pcs
Site master
Site master


Joined: 18 Jan 2002
Posts: 3063
Location: Radio Land

Post Reply with quote
This is a free forum, all kinds of posts from all kinds of people.

It is not: "You ask, PCS stuff answers" kind of thing.
This forum is here for you, people interested in low power radio
broadcasting. If you want to turn it into a piggery ascribe this
to yourselves.

Its more like: "You ask, everyone answers". Just be prepared to
get all kinds of responses, good and bad.

If you've got a question for Pcs electronics please use the feedback form
or email provided.

_________________
Best regards,
Marko - PCS Electronics
--------------------------------------------------------
Turn your PC into a FM radio station!
http://www.pcs-electronics.com
fax +386 4 2316 128
Tue Jun 22, 2004 1:33 pm View user's profile Send private message Visit poster's website
Display posts from previous:    
Reply to topic    PCS-Electronics Forum Index » FM transmitters All times are GMT + 1 Hour
Page 1 of 1

 
Jump to: 
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group