Patching a to lcd module maxpro3000

Discuss computer software and hardware with other users...(SW limiters, audio processors etc)

Moderators: Sir Nigel, Nina, pcs, 5r, phpBB2 - Administrators

Post Reply
User avatar
Mayhemsound
New registered user
New registered user
Posts: 1
Joined: Sun Jun 14, 2015 7:38 am
Location: Wellington

Patching a to lcd module maxpro3000

Post by Mayhemsound »

I've recently purchased and set up a maxpro3000 with a Se 2000 encoder. I'm still testing but early results are very impressive with great clarity and reasonable range even at low power.

I'm keen to patch a PC to the system so I can monitor all parameters via the studio PC instead of grovelling around in the rack.
I see the pins on the lcd display board for doing this but have no idea where to start. usb or Rs 232?

can I connect USB direct to these pins?

Does pcs manufacture a patch lead to do this?
User avatar
pcs
Site master
Site master
Posts: 3132
Joined: Fri Jan 18, 2002 1:00 am
Location: Radio Land
Contact:

Post by pcs »

http://www.pcs-electronics.com/max-pro-3000-p-1317.html

USB IO board+

Connect this to your LCD display and you'll have PC remote control.

You can't connect LCD to RS232 or USB directly with just some wires, interface is needed (IC + some resistors and capacitors + connectors)
Best regards,
Marko - PCS Electronics
--------------------------------------------------------
Turn your PC into a FM radio station!
http://www.pcs-electronics.com
fax +386 4 2316 128
Post Reply