100W 평면 FM 팔레트 증폭기(12-15V)

설명

100W with low voltage 12-15V 

This 100W pallet has been designed for applications requiring low supply voltage (10-15V), high efficiency and excellent wideband frequency response. It can produce full output power @ 15V with about 2W of drive power across entire band even at band edges. Peak power at band center is well above 100W.

Each pallet amplifier we sell is designed and tested using vector network analyzer and spectrum analyzer. Our amplifier products are manufactured using an automatic surface mount assembly process. This pallet is optimized for 10-15V operation and is perfect for battery-powered mobile applications and solar powered applications. Using a lower voltage will result in lower output power. It will operate down to about 10 volts with reduced output. As with any pallet you will need a heatsink, power supply and filter to use it. More information is available in the included amplifier data sheet.

Any of our exciters capable of producing at least 2-3W is suitable to drive this pallet amplifier. Two or more of these pallets can be combined to create 200W  or more from battery power. Using solar panels for your radio transmitter? This might be your dream solution.

기술 사양:
– FM band, 87.5MHz to 108MHz, will work from 80 – 120MHz at reduced power (also available for 81, 144MHz and other frequency bands, email for info)
– 입력/출력 50옴.
– Pout: >100W even at band edges
– Drive power required: ~2W
– Requires 10-15Vdc (100W/8A)
– 바이어스 조정이나 RF 회로 튜닝이 필요하지 않습니다.
– Size V1 100W: 48x102mm, ~35mm high

You can find suitable filters 여기.
적합한 주전원 공급 장치는 다음과 같습니다. 여기.
경고: Do not exceed maximum supply voltage of 15V or damage will occur.

참고 1: 사용 해주세요 PTFE 동축 케이블 RF 입력(RG178이 완벽함) 및 출력(RG178 또는 RG142가 완벽함) 연결의 경우 동축 케이블을 태우지 않고 매우 짧은 리드를 가질 수 있습니다. 동축 리드를 가능한 한 짧게 유지하십시오(최대 몇 mm). 또한 커넥터의 리드선을 짧게 유지하십시오.  RG142 또는 .141 반강성용 N 암 플랜지 - 쉬운 설치 완벽하다!

노트 2: 작은 방열판이 반드시 필요합니다!

노트 3: The actual product differs from the one on the photo. We do not have photos yet of this pallet.