PCS-Electronics

I cant get my MAXPRO3+ to tune to 91.9

I dont have the LCD board, so im trying to use the dip switchs.
can somebody PLEASE tell me what postion the 4 dip switchs are suppose to be in as well as the other 8 PLEASE!

i just cant get it to goto 91.9 arrrgggg...

thanks

What can you get it to?

Have you checked the manual?

Marko

Hi Marko,

Its not that the unit wont tune there,its that the manual dip switch settings i cant
figure out...so Again, simple question, what position are they (the dip switches) suppose to be in on
both the 4 and the 8 dip switch panels?
thanks,
doc

But have you looked at the manual? It lists dip switches for all freq.

YES! I have but they DO NOT WORK! i get 103.7 instead of 91.9

Maybe im reading the manual wrong..thats why i am asking a SIMPLE
question.... What are the settings for each set of dip switches Please.

The switches follow the simple binary system.

small 4 switches go from 6.25 - 12.5 - 25KHz to 50KHz
The 8 switches go to: 100KHz, 200KHz, 400KHz, 800KHz, 1600KHz, 3200KHz, 6400KHz, 12800KHz

When they're all set to 0, the board transmits at 86MHz. Now whatever you set on the switches
is added to 86000KHz and you've got your frequency.

Follow the examples and you should be able to work it out easily.

If not, there's still LCD unit, which is really easy to use

Do you have a freq. meter or are you using a receiver to figure this out? A receiver
could be tuning into a spurious signal.

hi mark,
could ya give me an example of what dip switches are set "on"
for the 4 & 8 dip switch panels so i can get 91.9

thanks,
scott

Example is there for 100.000 MHz

The settings are also in the table. If I give it to you, it will look
exactly the same as in the table.

ok...let me ask you this then...i know where to set the 8 dip switches, for 91.9, but
where do i set the 4 dip switches at?

i just cant figure this out?

What do the instructions tell you to do with 4 small switches?

1,0,0,0

Duh