hi,
a few months ago , i ask a question about the number of screws in your transmitters, i have an enclosure from another manufacturer there are only 4 screws on the top and bottom of the unit , can i use aluminum adhesive backed tape to seal the RF from escaping?
aluminum adhesive backed tape to seal the RF from escaping
Moderators: Sir Nigel, Nina, pcs, 5r, phpBB2 - Administrators
- stylzmovement
- Compulsive poster:)
- Posts: 142
- Joined: Sat Oct 11, 2003 8:59 pm
You can, but there is no real need for that.
It may be usefull in environment where you have lots and lots of transmitters/receivers
in one room, such as in a radio tower with tv/radio transmitters.
In a single unit installation or small installation its not needed and there will be no
noticeable difference.
It may be usefull in environment where you have lots and lots of transmitters/receivers
in one room, such as in a radio tower with tv/radio transmitters.
In a single unit installation or small installation its not needed and there will be no
noticeable difference.
Best regards,
Marko - PCS Electronics
--------------------------------------------------------
Turn your PC into a FM radio station!
http://www.pcs-electronics.com
fax +386 4 2316 128
Marko - PCS Electronics
--------------------------------------------------------
Turn your PC into a FM radio station!
http://www.pcs-electronics.com
fax +386 4 2316 128