New product/manual: SE3000 AN+

Manuals and drivers for all products, erratas, problem report and solutions and related topics...

Moderators: Nina, pcs, 5r, Boris

Post Reply
User avatar
pcs
Site master
Site master
Posts: 3131
Joined: Fri Jan 18, 2002 1:00 am
Location: Radio Land
Contact:

New product/manual: SE3000 AN+

Post by pcs »

http://www.pcs-electronics.com/se3000an ... -1270.html

Image

Here is the manual:
http://www.pcs-electronics.com/software ... dsp_en.pdf

The compressor in this stereo encoder is the same that was used in Limbo I and Limbo II.
Many liked this very much so here it is again now in a brand new package with extra sharp filters.
Best regards,
Marko - PCS Electronics
--------------------------------------------------------
Turn your PC into a FM radio station!
http://www.pcs-electronics.com
fax +386 4 2316 128
User avatar
pcs
Site master
Site master
Posts: 3131
Joined: Fri Jan 18, 2002 1:00 am
Location: Radio Land
Contact:

Errata

Post by pcs »

Errata for SE3000+:

1.) The phase and pilot level trimmers are interchanged, that is
the text next to pilot trimmer should say phase and
the text next to phase trimmer should say level.

2.) The pre-emphasis jumpers were not placed correctly for
the first batch of cards. This just means that you have to remove
the two pre-emphasis jumpers and place them at an angle of 90
degrees compared to where they were before. With other
words, they should be in line with the red capacitors next to them
and not perpendicular to them. Since this does not require soldering
but just placing a simple jumper elsewhere it is not a big
problem.

SE2000 is the same as the SE 3000, the only difference is that the 2000
has compressor disabled. If anyone wishes to modify their 3000 AN+ card
into 2000 AN+, please drop me an email or private message and I will
email you instructions, it is a 10-minute soldering job.
Best regards,
Marko - PCS Electronics
--------------------------------------------------------
Turn your PC into a FM radio station!
http://www.pcs-electronics.com
fax +386 4 2316 128
Post Reply