Page 1 of 1

Patching a to lcd module maxpro3000

Posted: Tue Jun 30, 2015 5:38 am
by Mayhemsound
I've recently purchased and set up a maxpro3000 with a Se 2000 encoder. I'm still testing but early results are very impressive with great clarity and reasonable range even at low power.

I'm keen to patch a PC to the system so I can monitor all parameters via the studio PC instead of grovelling around in the rack.
I see the pins on the lcd display board for doing this but have no idea where to start. usb or Rs 232?

can I connect USB direct to these pins?

Does pcs manufacture a patch lead to do this?

Posted: Wed Jul 01, 2015 10:59 am
by pcs
http://www.pcs-electronics.com/max-pro-3000-p-1317.html

USB IO board+

Connect this to your LCD display and you'll have PC remote control.

You can't connect LCD to RS232 or USB directly with just some wires, interface is needed (IC + some resistors and capacitors + connectors)