DIP frequency selection and comparison
Posted: Thu May 28, 2020 7:54 pm
Considering buying the MaxPro 2015 V2.
I cannot find specifics for DIP switch setting for frequency selection.
Will the DIP switch’s give full band frequency selection possible , or only a factory limited group of frequencies?
The manual seems designed for use with optional control boards and little info on DIP /jumper use only.
The product info describes this unit as being updated to “version 3”, yet price list and item description only shows “-V2” (version 2)
Which version is shipped and price ? (Appear to be V2, but no where to buy V3)
Is Version 3 available for purchase and cost .?
Finally, I am looking for better spectral purity and fewer spurs vs price.
Considered the DDS STMAX 3015+ VS the Maxpro 2015+
It is primary for talk radio, so mono ok at this time (and for better range?)
However high currency exchange rate and delivery costs to Canada also affects decision . (This makes inferior Chinese product at 1/2 the price a temptation, but have had micro-controller failure a common problem )
Naturally, reliably between the 2 PCS choices is a factor.
Any advice appreciated.
Tnx
Joe
I cannot find specifics for DIP switch setting for frequency selection.
Will the DIP switch’s give full band frequency selection possible , or only a factory limited group of frequencies?
The manual seems designed for use with optional control boards and little info on DIP /jumper use only.
The product info describes this unit as being updated to “version 3”, yet price list and item description only shows “-V2” (version 2)
Which version is shipped and price ? (Appear to be V2, but no where to buy V3)
Is Version 3 available for purchase and cost .?
Finally, I am looking for better spectral purity and fewer spurs vs price.
Considered the DDS STMAX 3015+ VS the Maxpro 2015+
It is primary for talk radio, so mono ok at this time (and for better range?)
However high currency exchange rate and delivery costs to Canada also affects decision . (This makes inferior Chinese product at 1/2 the price a temptation, but have had micro-controller failure a common problem )
Naturally, reliably between the 2 PCS choices is a factor.
Any advice appreciated.
Tnx
Joe