PCS-Electronics

Muy buenas,

llevamos unos años emitiendo con una emisora CyberMaxFM de 300W. Hemos cambiado de centro emisor y de dial. El problema esta en que, al pararla antes mover la emisora, bajamos la potencia al mínimo. En la nueva ubicacion, la conectamos a una carga fantasma, cambiamos el dial, pero al intentar volver a subir la potencia, no responde y se queda fija al mínimo. ¿alguna idea de donde puede venir el problema? Muchas gracias por adelantado.


We have been broadcasting with a 300W CyberMaxFM transmitter for a few years. We have changed the transmitter and dial center. The problem is that, when we stop it before moving the station, we lower the power to the minimum. In the new location, we connect it to a phantom charge, change the dial. When connected to the new radiant system and try to raise the power again, it does not respond and remains fixed to the minimum. Any idea where the problem might come from? Thank you very much in advance.

If it works normal with dummy load and does not work with antenna the problem is clearly connector, cable or antenna system on new location.

We've tried with a dummy load and, even setting the rf power to the maximum, it still says "O W".

The transmitter gives no error message at all; when we've opened it, the only strange thing is that one of the fans is stopped, the one on the left,
but we don't know if it is because the temp is low.

Do you have any clue which may be the problem?

[/img]

I would advise that you send it to us for a check. Contact us via e-mail to arrange this.