Testing LDMOS transistors with DMM multimeter

Discussions regarding our FM transmitters, DX reports, antenna designs, problems...

Moderators: Sir Nigel, Nina, pcs, 5r, phpBB2 - Administrators

Post Reply
User avatar
pcs
Site master
Site master
Posts: 3131
Joined: Fri Jan 18, 2002 1:00 am
Location: Radio Land
Contact:

Testing LDMOS transistors with DMM multimeter

Post by pcs »

This is a very usefull text:

http://www.embedded.com/print/4219409

All too often today, one or more of the following field-testing issues are encountered:

Issue #1
Technicians literally grabbing an RF power transistor and testing it “free form” with a battery powered multimeter (using either the ohmmeter or diode setting).

Problems Caused
It is impossible to properly test leakage current with a battery powered multimeter. The output voltage and the meter’s impedance are completely unknown. This will certainly lead to invalid and/or unreliable readings. Remember, the DUT must be tested under the correct voltages, and the correct conditions, to guarantee reliable and repeatable results. Using a multimeter, no details regarding the DUT’s actual leakage current level can actually be measured or recorded in any meaningful way. A battery-powered multimeter can only reliably be used to test whether a clearly already defective DUT is either “open” or “shorted.”

Issue #3
Static discharge is applied to the DUT (improper device handling).

Problems Caused
Static discharge can and likely will ruin (forever) an otherwise good device.

Issue #4
Improper grounding/shielding/isolation methods are employed with the DUT.

Problems Caused
Testing with improper shielding, grounding, and isolation will lead to erroneous and invalid measurements; and it may also damage the part.

Improper Testing Lead to These Unfortunate Consequences:
- Both “good” and “bad” devices are being damaged unnecessarily, and this makes further analysis impossible.
- Some devices that are actually within specification are being thrown away or being rejected/returned because of erroneous test results.

Conclusion: DO NOT TEST RF LDMOS WITH DMM multimeter!
Best regards,
Marko - PCS Electronics
--------------------------------------------------------
Turn your PC into a FM radio station!
http://www.pcs-electronics.com
fax +386 4 2316 128
Post Reply