PCS-Electronics

Thank you for your reply. It is expennsive to send the kit back to you althought you will check inexpensively for us. Can you gve us some orther advices?
Thanks.

Dear sir,
We have a Max pro 3 working well on 5-6 years. Now we have a problem of frequency. We set it 91.7 MHz, but the transmitter actually working on 90.8 MHz, about 1MHz lower. Can we now adjust it somehow.
Thank you and best regards.

Yes. We received them but, very sorry, then we lost the links.

Please send us again the software as mentioned. We are sorry we missed it somewhere. Thanks.

Pls advise me how to use this IO board with MAX PRO 3000+.
Thank you.

Yes. We tried 1V, 2V, 4V but nothing changes coder audio level out. We have I2C connected.

We have now other problem. We used SE3+ stereo coder before and very satified with it. Now we have SE4 DSP+ and found that the ouput audio level is very low. The input is standard. Has anyone an advise for me?

Its a bit long. I suggest you try 2 things for a start: 1.) Make sure ground connection is correct. Now try to swap the other two around. 2.) Try to shorten it up a bit, at least for a test. If this fails, look at the two diodes close to eachother on the SE4 board. Replace one of them with a low-dr...

pcs wrote:Did you connect I2C cable? Yes, the cable supplied by PCS.

How long is the cable?

It is about 20cm

1. We connect SE4 DSP+ with MAX PRO3 and the LCD informs ERROR, we think the pins are in correct place.
2. We do not connect the cable above. The audio signal through SE4 DSP and SE4 DSP+ and MAX PRO3 is very noisy and weak.
Please help by some advises ASAP.
Thanks