PCS-Electronics

OK, one more then I'm done... [snip] at 1/4 λ and 5/8 λ--the results are interesting and although pefromed for the 2 meter ("146 MHz") band they remain relevant at 3 meters. The bottom line is that for high mounted antennas the 5/8 λ has very little practical ad...

Holliday wrote:Is it a huge crime to use 6 or 11u for the antenna? It wont hurt the PCI MAX will it?

They are both 75 ohm cables. spend a few dollars on the correct stuff.

hahaha yea When the transmitter is at its full power you can feel the induction in your body. Thats why I have the stay 3 feet away from the window rule when someone visits. (I try to keep it down to about half a watt) but sometimes I get a little on the adventure side and crank it up :lol: Beautif...

do TV channels 4, 5, & 6 in north america run the audio portion in am or fm format?

What about UHF TV is the audio fm or am ?

[quote="Polo_Thug"] http://www.freewebs.com/polo_thug/index.htm [snip] not 100% sure on the SWR meter reading part. When I put it in REF and turn the knob to the middle it reads in the red and when I put it on FWD it pegs out. You have it backwards #-o Set the meter to "Swr" then...

Can anyone explain how i can earth a Half Wave Open Dipole Antenna.. Is there a (rational and affordable) way to protect the transmiter in case lightening hits the antenna? Regards I live in a very heavy lightning area. We switch the exciter into a dummy load if Lightning is closer than 2 or 3 km. ...

I need an ISA version of the older PC MAX card. Ideally the last of them before Marko went to PCI based cards, they could work with the linux driver or the windoze driver. Please leave me a message if you are looking to upgrade your station and no longer need the older card. I promise to give it a g...

:D Handsome little radio...Where do you buy one? There are radios that are coming out commercially in about 6 months. The developer kit which includes one board and lcd display, power supply and documents is a bit steep at $1,500.00 Cheap if you are making 1,000,000 to 10,000,000 radios. Not so che...

Just add directional antenna and low current power source.

http://www.reciva.com/home.htm

do you tune this antenna the same way you tune the 5/8 antenna or is it set at the same frequency for good... Pretty much for good. That is why you do an open frequency search first! You could rewire it with out too much hassle. The slim jim antennas are good for over one mhz either side of where t...

In terms of money spent, you CAN get out FARTHER WITH LESS. - DEPENDS ON HOW YOU DO IT. The antenna is the place where you will get the most bang for your buck, IF you know how to bang. It's not the size of the hammer, it's the technique of the Carpenter :) Lets say you have 200.00 to spend on anten...

>Which antenna provides the best performance for a non-directional application under >100w ERP? Considering, a 5/8 wave vs a single or dual dipole type. I have seen a 5/8 comet beaten by a home made slim jim for about one tenth the cost. See http://geocities.com/juliusno1776/ The slim jim focuses it...

Newbie here. I am looking for an antenna to give me an umbrella over my house (2 story) and not spread to the neighbors. Ideas / suggestions? I suggest a leaky coax antenna for use at ones home. Take some very cheap low quality RG-58 the kind that has poor outer braid covering. Use 10 feet and plac...

Marko is correct on the match. both RG-8 and RG-58 are 50 ohm cables. If you are running more than 25 feet from the amp to the antenna, you are loosing some of the power that could be running out the antenna instead of the heat generated by the high relative loss that RG-58 gives you at 100 mhz. You...

http://www.geocities.com/juliusno1776/
Save your money for a good exciter, this antenna outperforms the Comet for one tenth of the money.

Could the linux driver written for the newest version of the ISA Max be modified to work with the older ISA Max ? ( 1 watt upgraded version of the original 750 mw. board ) Anyone have some information on what has to be done? Also, Is it possible to write a DOS driver to set Frequency and have power ...

1 -The voltage of your power supply might be different in each computer. Some BIOS will read voltage of system power supply. -check the BIOS 2 -the small coils on the board, if squeezed or stretched one way or another can effect power output. check if they moved when you handled the board from one c...

Pinpoint? there are other ways ,,,If you ever give a phone # out,,, Ditto Pager #'s Email address, especially if it's your isp address make friends online here or elsewhere,,, some ditty dah hams have a hard on for pirates, a very few hams like pirates, understanding the NABr's have ruined our free ...

How much trouble is it to make a small PLL board 100+ Mw. that is mountable at the top of antenna mast with a whip antenna above it that is full legal length so as to be legit in US ? -something that is mountable inside a short length of 2" pvc pipe to weatherproof. Same board can be made for i...

pcs wrote:LPF is a bitch with these, would you mind if there were no LPF?

If you mean a low pass filter, I think that's a necessary "option"

I would like a low pass external filter that is tunable. E F Johnson used to make a
tunable filter that worked very well.