الوصف
Elevate your ham radio experience with our advanced 2m all-mode wideband amplifier, featuring the latest AMPLEON transistors. This high-performance amplifier utilizes a single AMPLEON LDMOS push-pull transistor, delivering up to 1200W peak power. Designed for superior performance, it requires an excellent heatsink.
المواصفات الفنية:
- Shipping Weight: 0.9 Kg
- Frequency Range: 144-146 MHz
- Voltage: 40-55V @ 28A
- معاوقة: Input/Output 50 ohms
- Output Power: 1000-1200W with ~10W input
- Gain: ~20 dB
- Class: B push-pull
- Temperature Compensated Bias: NXP design
- Size: 4.0 x 2.25 x 1.5 inches (LxWxH)
- Base: Standard 1/4 inch copper
- Integration: Bias disable pads for automatic VSWR protection systems
الأهمية:
– Ensure proper shielding between the final stage and audio stage with exciter. Install a good مكثف التغذية on the +48V supply wiring to prevent RF interference.
– Excessive drive levels can damage the amplifier. Ensure your equipment includes appropriate protection circuits.
– Amplifier efficiency is dependent on supply voltage. For maximum efficiency, adjust the supply according to the desired output power, typically at 1-3 dB gain compression.
– RF pallets are sensitive. If you lack sufficient experience, consider a fully finished product. Misuse can lead to damage, and no warranty is provided. Every pallet is tested and fully operational upon dispatch.
– Ensure proper airflow across the pallet to prevent overheating. Pre-order now to secure yours!
– You can find special adjustable 50-65V power supply for this amplifier هنا! Use a good strong fan!
Manuals and drivers for most products are available under the Additional Information tab above, just under the prices. Some old manuals are هنا.
If your web browser blocks the download, you may have to allow it manually. You can send us questions هنا.
Warnings and Notes:
– Do not exceed maximum supply voltage for your pallet to avoid damage.
- يستخدم كابل محوري PTFE for RF input (RG178) and output (RG178 or RG142). Keep leads very short. This N شفة أنثى لـ RG142 أو .141 شبه صلب - تثبيت سهل مثالي!
– A heatsink is essential. Ensure proper airflow across the pallet to prevent overheating.
الملحقات الموصى بها:
نوصي antenna analyzer for checking SWR of the antennas. Grounding kits for lightning protection can be purchased هنا. They should be installed at the antenna (if needed, most dipoles are grounded anyway), at the tower base and at the point of entrance into transmitter building. Also use شريط الختم الذاتي which turns into rubber and protects moisture from entering your antenna system. You might also need Antenna tower to place the antennas. الكابلات والموصلات المحورية are available as well.
المراجعات
لا توجد مراجعات بعد