PCS Electronics, radio and TV transmitter superstore! Chat with our engineers or leave a message English Espanol Portugues Norwegian    
  Topp » Katalog » FM radio antennas » Min konto  |  Handlekurv  |  Sjekk ut   
Våre produkter
FM transmitters->
AM transmitters
Special sale items
RF accesories for transmitters->
FM amplifiers->
FM radio antennas
TV Transmitters->
TV amplifiers->
TV antennas
Coaxial cable and connectors
RDS Encoders
Stereo encoders
Wireless audio/video links
Electronic components->
Cool Stuff->
Solar power
Studio equipment->
DEVA Broadcast->
RF service and design
Hva er nytt?
Basic Studio (mixer and microphone)
Basic Studio (mixer and microphone)
Våre radioguider
Hvordan starte guide
Making Your Own Transmitter
Nye skjema
Anbefalt lesning
Om PCS Electronics
Forsendelse & Retur
Tilgjengelig på lager
Kontakt oss
Affiliate Program
Affiliate Information
Affiliate Program FAQ
Affiliate Log In
Gavekort FAQ

PayPal and credit cards accepted!
RF antenna dividers/spliters/combiners  

FM power dividers allow more than 1 antenna to be added to your antenna system to increase gain, range and sometimes to obtain desired radiation pattern. Every time you double number of antennas you get 3dB of gain (ok, there are also some minimal losses to consider). You need 6dB or a bit more of gain to double your range. This means upgrading your single dipole to 4-dipole antennas doubles your range and increases your effective radiated power to 4x of the initial value.

Quick comparison:
- 1kw transmitter + 1xdipole antenna: ERP=1KW, antenna gain = 0dBd
- 1kw transmitter + 2xdipole antenna: ERP=2KW, antenna gain = 3dBd
- 1kw transmitter + 4xdipole antenna: ERP=4KW, antenna gain = 6dBd
(This is assuming no losses in coaxial cable and combiners)

Several combiners are listed and described below, select the one that fits your requirements and budget best.

Coaxial splitter (2-way or 4-way), first two options down on the list
Low cost solution that gets the job done just fine. Coaxial cable to the antennas does not have any connectors installed yet, you will have to do that. 3 cm of cable can be stripped to install a connector on each of the splitter cables. Cutting off any piece of coax would change the frequency band of the splitter so be carefull.

Technical specifications:
- MAX Power handling: 750 Watts
- Inputs to antenna: No connector, you can strip 3cm on cable ends to install a connector
- VSWR: better than 1:1.5 (88-108MHz)
- Freq. range: 88-108 MHz(no tune)
- Output to transmitter: 750W
- Weight: 3Kg

Specifications for remaining splitters:
Simple to install, these power dividers are ideal for feeding an array of antennas to allow you to increase your signal coverage area, they are equipped with connectors. You will need inter-bay cables to connect the splitter to the individual dipoles. These cables should be 50 ohms and all of exactly the same length.

Technical specifications:

- Input connectors: N female, 7/16 or IEC (read product name, for example 2KW 4-way power divider (4xN female+7/16) means 4xN connectors going to antennas/dipoles)
- Output connectors: N female, 7/16 or IEC (read product name, for example 2KW 4-way power divider means 7/16 output connector going to transmitter)
- Maximum power handling: read product name, for example 2KW 4-way power divider (4xN female+7/16) means power handling is 2KW transmitter max 
- Easy installation

Important: Due to large size and irregular shape of these packages the website often gets shipping cost wrong. Also sometimes we have to use wooden case which adds about 100 euro to the cost of antenna. For exact shipping cost please contact our sales department, be sure to give them your exact address and they will quote you shipping. It also does not hurt to ask for a special discount.

Recommended accesories:
We recommend AA-170 antenna analyzer for checking SWR of the antennas. Grounding kits can be purchased here, they ensure lightning protection. They should be installed at the antenna (if needed, most dipoles are grounded anyway), at the tower base and at the point of entrance into transmitter building. Also use self-sealing tape which turns into rubber and protects against moisture from entering your antenna system.

Dette produktet ble lagt til katalogen Friday 08 May, 2009.
 *Valg antall for varene du vil kjøpe og velg \Legg i handlekurv' knappen.
Viser 1 til 10 (av 10 produkter) Resultat sider:  1 
    Navn   Modell   Velg   Pris 
800W 4-way power divider (5xN female)  800W 4-way power divider (5xN female)   GACN/4N  232.99EUR
2KW 2-way power divider (2xN female+7/16)  2KW 2-way power divider (2xN female+7/16)   GACM/2N  249.99EUR
2KW 3-way power divider (3xN female+7/16)  2KW 3-way power divider (3xN female+7/16)   GACM/3N  269.00EUR
2KW 4-way power divider (4xN female+7/16)  2KW 4-way power divider (4xN female+7/16)   GACM/4N  279.99EUR
3KW 2-step 8-way power divider (8xN female+7/16)  3KW 2-step 8-way power divider (8xN female+7/16)   GAXM/8N  449.99EUR
5KW 2-step 8-way power divider (8xN female+7/8)  5KW 2-step 8-way power divider (8xN female+7/8)   GAXF/8N  482.00EUR
2500W 1-step 2-way divider (2x7/16 + 7/16)  2500W 1-step 2-way divider (2x7/16 + 7/16)   ECOMAX  164.99EUR
2500W 1-step 3-way divider (3x7/16 + 7/16)  2500W 1-step 3-way divider (3x7/16 + 7/16)   ECOMAX  174.99EUR
2500W 1-step 4-way divider (4x7/16 + 7/16)  2500W 1-step 4-way divider (4x7/16 + 7/16)   ECOMAX  184.99EUR
10000W 2-step 4-way divider (4x7/8 + 1 5/8)  10000W 2-step 4-way divider (4x7/8 + 1 5/8)   ECOMAX  609.99EUR
Viser 1 til 10 (av 10 produkter) Resultat sider:  1 
0 varer

Bruk kodeord for produktet du ser etter.
Besøk vårt forum
Siste poster:

Besøk forumet
Google™ translate
English French Spanish
German Italian Portuguese
Korean Japanese Arabic Greek Turkce

Andre valuta

Kontakt oss | Om PCS Electronics | Support | FAQ | Hvordan starte guide | Forsendelse & Retur
Show prices In US$ | Show prices In EUR | Manualer, programvare og support

All tekst pa denne siden, produkt beskrivelser, guider og script
Kopirett © av PCS Elektronik d.o.o.
Laget av osCommerce