200W, 400W, 600W and 1000W VHF TV AMPLIFIERS in 2H rack

 3,49 2.999,99

In stock
 1.399,99

In stock

 1.999,99

In stock

 1.999,99

In stock

 2.999,99

In stock

 3,99 7,99
 5,99 108,00
 69,99

In stock

Prices shown are without VAT (paid only in EU)

Description

200W, 400W, 600W and 1000W fully adjustable with SWR/POWER meter and SWR protection

Our new family of digitally controlled TV amplifiers in rack enclosure finally brings the benefits of all-digital control. You can now comfortably set the output power with the UP/DOWN keys and check the SWR, internal temperature or RF output power at any time with a simple glance at the LCD display. SWR protection is of course included. Look no further if you’re looking for a reliable TV amplifier with the comfort and ease of LCD operated digital control system.

Employing the latest RF techniques for an ultra-stable high effeciency design. This unit is supplied with a universal input switched mode power supply and is built into a nice looking 2H 19-inch rack enclosure. This can be used with any mains voltage system in the world. A built in heatsink and fan assembly provides more than adequate cooling to the unit ensuring 24/7 operation. On board harmonic filtering provides that needed reassurance that your signal is where it should be. Accepts 5mW input, but can be modified to accept higher power levels.

You can find the manual for this (and other products) here.

Technical specifications:
– Power Output: 200W, 400W, 600W and 1000W (depending on model)
– Output connector: N-connector
– Output Impedance: 50 Ohms
– Power Input: 2-10W (depending on the model, please specify drive power at time of ordering)
– Input Impedance: 50 Ohms
– Input connector: BNC (ask for SO239 or N)
– Frequency Range: 175-225MHz (VHF LOW is available but will cost more, contact us for a quote)
– RF output ruggedness: SWR protection with reduced power, over-voltage protection, over-current protection, temp protection
– Spurious/Harmonic rejection: Use external notch filter for your channel
– Power Supply: Mains 110V-240V (50/60Hz), works everywhere
– Ultra Stable, Ultra Clean Output
– SWR meter with alarm: LCD display
– RF power meter: LCD display
– 2 TEMP meters with 2 alarms: LCD display
– SWR protection: Reduced power with LCD warning, lights RED led, beeps
– Current consumption meter with alarm: Reduced power with LCD warning, lights RED led, beeps
– RF drive indicator and alarm: Reduced power with LCD warning, lights RED led, beeps
– No Expensive Test Equipment Required to setup, no SWR meter required to setup (although one is always recommended)
– Rack size: standard 2H 19 inch rack
– Full PC remote control via RS232 or USB

Why is this VHF TV AMPLIFIER so great?
One might think one of the RF amplifier modules would be enough, but reality is often far from that. Just the basic coaxial cable wiring represents a major problem to many users. Than there’s the issue of SWR protection, which most modules don’t offer, and RF power, SWR and TEMP measurement and display on LCD, which is not just convenient but often helps monitor operation and eliminate the problem fast or even before it happens. Another strong point is the mains power supply, most modules are shipped with PSU that’s just barely able to cope with the load, usually quitting after a couple months, or, as Murhpy would have it, just a few days after warranty expires (in the middle of the top radio show).

A relatively modest additional investment in a better equipment is rewarded by reliable operation, convenience and peace of mind. Here’s a quick summary of the benefits:
– Digital control, you can now adjust output power to a desired value
– Built-in SWR and RF POWER meter
– SWR protection
– No hassle, easy to use
– Mains operated
– Over-dimensioned mains power supply

What parameters can I change via remote control?
Its best that you look at the screen capture below. The program may change slightly over time as we make enhancements, but the main features will remain as below:
You can basically change all available parameters and put unit into standby mode, if desired.

PC control software, normal size

 

 

Additional information

Reviews

There are no reviews yet.

Only logged in customers who have purchased this product may leave a review.