PCS Electronics, radio and TV transmitter superstore! Chat with our engineers or leave a message English Espanol Portugues Norwegian    
  Topo » Catálogo » Stereo encoders » Minha Conta  |  Conteudo do cesto  |  Verificação Final   
Categorias
Special sale items
FM transmitters->
RF accesories for transmitters->
FM amplifiers->
FM radio antennas
TV Transmitters->
PC Transmitters
TV amplifiers->
TV antennas
Coaxial cable and connectors
RDS Encoders
Stereo encoders
Wireless audio/video links
Instruments
Electronic components->
Software
Cool Stuff->
Solar power
Studio equipment->
DEVA->
RF service and design
AM transmitters
O que há de novo?
100m drum CellFlex 1+5/8 inch
100m drum CellFlex 1+5/8 inch
1,796.95US$
Nossos Manuais de rádio
Como Começar
Questões Frequentes
Making Your Own Transmitter
Cabo Coaxial
Equipamento de Audio
Esquemas
Novos esquemas
Wizards
Amplificadores
Antenas
Power Supply
Recomendado Lêr
Soldar
Comentarios
Informação
Sobre PCS Electronics
Entrega e devolução
Requisitar
Sopporte
Actual Stock
Questões frequentes
Forum
Contacte-nos
Distribuidores
Nota de Privacidade
Affiliate Program
Affiliate Information
Affiliate Program FAQ
Affiliate Log In
Vouchers
Cheques prenda FAQ
Seguran‡a


PayPal and credit cards accepted!
SE2000+ stereo encoder with digital audio  


Now with digital audio for stunning noise-free audio

You can find the manual for this (and other products) here.

A solid performer, 7th order eliptical digital filter provides excellent attenuation above 15KHz (LPF, low pass filter) and a deep notch at 19KHz. Exactly as specified by the standards. There are clippers at the input as well to take care of excessive peaks. This unit is similar to the SE3000+, but we took out the compressor and installed digital audio input. Connect to your PC USB port and stream audio directly. A new encoder was born; a high performance stereo encoder with elaborate filter circuitry and noise-free audio straight from your PC. We have to admit, this unit does sound extremely well and is sure to please many golden ears out there. To recapitulate, we have a built-in precise LED limiter and balanced inputs, sharp 19KHz stereo carrier notch filter (>60dB), pre-emphasis, excellent channel separation and sharp low pass filters all help to bring out really crisp sound. SE2000 + can even be upgraded to RDS functionality simply by plugging-in a RDS daughter board. It is perfect for a demanding, but cost-conscious broadcaster. SE2000 AN+also comes with a new MaxLink connector, designed to connect stereo encoder to our fm exciters. This connection lets you select stereo/mono via the FM exciter's LCD module and also provides supply voltage for its operation.
SE2000 AN+ will make sure your signal stays where you want it, providing high quality audio with excellent channel separation without causing interference to nearby channels. High quality components and printed circuit board assure 24/7 operation for years.

Why is SE2000+ so great?
- Digital audio interface is supported by Windows automatically without installing any drivers. Enjoy incredible noise-free audio. Forget ground loops.
- Perfect for any FM transmitter, several output levels can be selected with jumpers
- Works without LCD control module
- Can be connected to our FM exciter and controlled via the same LCD module (mono/stereo mode selection).
- Extremely sharp elyptical filters with a deep notch at 19KHz!
- Drop-in replacement for SE3000/SE4000/5000 DSP+!
- Balanced or unbalanced audio inputs. This effectively eliminates annoying ground loops and hum.
- LC filtered MPX output signal.
- Built-in limiter
- 3-pin header for VU meter added (check VUMAX-1)

Technical specifications: - Audio Response: 10Hz-15KHz, DSP filtered (Standards require upper level at 15KHz)
- 19KHz notch filter, >60 dB typ
- Precise pre-emphasis, 50uS, 75uS or none
- Audio Input Impedance: 10Kohm, balanced or unbalanced
- Audio Input Level: 0 dB
- Distortion: <0.1%
- S/N ratio: >90 dB
- Separation: >60 dB typ. (more than any radio receiver you can buy on the market)
- Pilot Frequency: 19 KHz, DSP generated 32x oversampling
- Output Impedance: 75 Ohms
- Power Requirements: 12-15VDC / 100-150mA
- PC Board Size: 100x85mm
- Audio connectors: all RCA jacks are mounted on the board, 3-pin jumper for XLR balanced input, optional MCX or solder pads for MPX output
- Power connector: 2.1mm power socket, center (+) and screw terminals (easier for boxed units)
- Output level: Ueff 4V, 2V or 1V
- Weight: 0.1Kg

Este produto foi adicionado ao seu catálogo em Saturday 21 February, 2009.
 *Por favor seleccione a quantidade que pretende para cada item e clique no 'Add To Cart' botão em baixo.
Mostrando 1 a 5 (de 5 produtos) Páginas de Resultados:  1 
    Nome   Modelo   Escolha   Preço 
SE2000D+ stereo encoder with digital input  SE2000D+ stereo encoder with digital input     79.99EUR  69.99EUR
10xSE2000D+ stereo encoder with dig. input  10xSE2000D+ stereo encoder with dig. input     599.99EUR
30cm Maxlink/I2C cable (FM exciter to stereo encoder)  30cm Maxlink/I2C cable (FM exciter to stereo encoder)     4.99EUR
2 x XLR/Canon connectors for panel mount  2 x XLR/Canon connectors for panel mount     6.00EUR
Replacement audio input IC  Replacement audio input IC     2.00EUR
Mostrando 1 a 5 (de 5 produtos) Páginas de Resultados:  1 
Carrinho de Compras
0 items
Pesquisa Rápida
 

Use palavras chave para encontrar o produto que procura.
Notificações

Sign up and receive special deals, discount codes, news and product updates delivered to your inbox. Emails are sent out ~ 1x/month.

Anúncios
Visita o nosso forum
ultimos comentarios:

clica para entrar no forum
Google™ translate
English French Spanish
German Italian Portuguese
Korean Japanese Arabic Greek Turkce
Moeda
   

Outras moedas

Contacte-nos | Sobre PCS Electronics | Sopporte | Questões frequentes | Como Começar | Entrega e devolução
Todos precios en US$ | Todos precios en EURO | Manuais, software e suporte

Todo o texto deste site, productos descrições, manuais e certeficados
Copyright © by PCS Elektronik d.o.o.
Powered by osCommerce