Hi,
I have a problem with the SE5000 DSP + stereo encoder.
When i configure the encoder for a 4 Vpp output, the level of the pilot I was shooting + 12 kHz deviation,
even with the jumper J12 jumpered.
It is possible to reduce the level of the pilot, without changing the output level of MPX?.
Thank you very much everybody.
Josep
Pilot 19 Khz level of SE5000 DSP + stereo encoder
Moderators: Sir Nigel, Nina, pcs, 5r, phpBB2 - Administrators
Yep, just swap one smd resistor and you can set it anywhere you want.
In fact pilot is a bit too high indeed, we have made changes to the current
SE5000 boards but yours was probably purchased before we made the
change.
E-mail me for a photo/instructions.
In fact pilot is a bit too high indeed, we have made changes to the current
SE5000 boards but yours was probably purchased before we made the
change.
E-mail me for a photo/instructions.
Best regards,
Marko - PCS Electronics
--------------------------------------------------------
Turn your PC into a FM radio station!
http://www.pcs-electronics.com
fax +386 4 2316 128
Marko - PCS Electronics
--------------------------------------------------------
Turn your PC into a FM radio station!
http://www.pcs-electronics.com
fax +386 4 2316 128