PCI MAX 3000+ MPX

All posts related to PCI MAX transmittors go here!

Moderators: Sir Nigel, Nina, pcs, 5r, phpBB2 - Administrators

Post Reply
berrall
Regular poster
Regular poster
Posts: 30
Joined: Thu Oct 14, 2010 1:49 am

PCI MAX 3000+ MPX

Post by berrall »

Hello,

Will the PCI MAX 3000+ accept a full MPX input via the anolouge input? The reason I am asking is I am looking to generate the MPX & RDS signal with Breakaway Broadcast and want to test with the PCI MAX to see the diffrence in sound qaulity with a view of upgrading to the MAX PRO 2000.

Do you think this will be a improvement over the PCI MAX with internal encoder and digital input?

Nick
User avatar
pcs
Site master
Site master
Posts: 3132
Joined: Fri Jan 18, 2002 1:00 am
Location: Radio Land
Contact:

Post by pcs »

Set it to mono and give it a try. It might work.

I would not expect a big improvement though.

I recommend a standard compressor / DSP processing, such as built into SAM:

http://www.pcs-electronics.com/broadcas ... p-366.html

With this or other similar sound processing engine you will rock the airwaves.
Best regards,
Marko - PCS Electronics
--------------------------------------------------------
Turn your PC into a FM radio station!
http://www.pcs-electronics.com
fax +386 4 2316 128
berrall
Regular poster
Regular poster
Posts: 30
Joined: Thu Oct 14, 2010 1:49 am

Post by berrall »

I tried it and did not let the full MPX signal pass through. I got very poor stereo seperation.

I already have SAM Broadcaster but found Breakaway Broadcast processor gives a far superior processed sound in every way. I use SAM as the player then into BBP then direct to the PCI MAX.

Without being able to test the diffrence I shall stick with what I have got.

Nick
User avatar
pcs
Site master
Site master
Posts: 3132
Joined: Fri Jan 18, 2002 1:00 am
Location: Radio Land
Contact:

Post by pcs »

Ok so use the on-board stereo encoder instead, it is pretty good.

You may find this interesting:
http://www.pcs-electronics.com/revoluti ... -1966.html

Right now it looks expensive since solar panels + charger + acus cost a lot, but you can
use this also with regular mains power cutting price in half.

Wherever you can get wlan or ethernet you can remotely control the transmitter and
stream audio in noise-free digital form.
Best regards,
Marko - PCS Electronics
--------------------------------------------------------
Turn your PC into a FM radio station!
http://www.pcs-electronics.com
fax +386 4 2316 128
berrall
Regular poster
Regular poster
Posts: 30
Joined: Thu Oct 14, 2010 1:49 am

Post by berrall »

Does the stereo encoder on this card use the Rohm BH1415F or simular coder chip?

Nick
User avatar
pcs
Site master
Site master
Posts: 3132
Joined: Fri Jan 18, 2002 1:00 am
Location: Radio Land
Contact:

Post by pcs »

We dont't use these cheap IC in any of our transmitters,
the encoders are discrete as they should be, with MPX filtering etc.


They can be however found in chinese stuff, all of them
have these IC inside.
Best regards,
Marko - PCS Electronics
--------------------------------------------------------
Turn your PC into a FM radio station!
http://www.pcs-electronics.com
fax +386 4 2316 128
berrall
Regular poster
Regular poster
Posts: 30
Joined: Thu Oct 14, 2010 1:49 am

Post by berrall »

I thought so, but as the IC's on the board have their markings removed I wanted to be sure.

On another note how can the poilet level be changed? on my unit the level is set at 5.1kHz according to my analyser which is well below the requirement of 6.0 to 7.5khz. What effect will the lower level it is currently set at have?
The RDS level can be adjusted by the preset on the board but there is no such adjustment for the 19khz tone.

Nick
User avatar
pcs
Site master
Site master
Posts: 3132
Joined: Fri Jan 18, 2002 1:00 am
Location: Radio Land
Contact:

Post by pcs »

It can be changed by changing one resistor value.

However you won't notice any change in audio so it
may be better to leave it as it is since it is working
well anyway.

If you are a perfectionist and still want to change it let
me know and I will email you instructions.
Best regards,
Marko - PCS Electronics
--------------------------------------------------------
Turn your PC into a FM radio station!
http://www.pcs-electronics.com
fax +386 4 2316 128
berrall
Regular poster
Regular poster
Posts: 30
Joined: Thu Oct 14, 2010 1:49 am

Post by berrall »

Yes please, if you could email the instructions. I will be able to judge then if it is worth undertaking the modification.

Nick.
Post Reply