 
|
DSP STEREOPREEMPHASIS/COMPRESSOR/LIMITER/BRICKWALL FILTER
Do you have problems with ground loops(buzzing or noise from PC) and overmodulation? Is your stereo pilot affected byyour audio content (no 19KHz notch filter)? Do you need a limiter/compressor?Preemphasis? Look no further, LIMBO II DSP is here!. It comes with latest in24-bit DSP technology, making it possible to create sharp filters, precisepreemphasis and compressors/limiters in a very small and reliable package,ensuring that crisp and powerfull sound you always wanted while making sureyou're not causing interference to nearby channels. Careful PC Board layout,precision IC amplifiers and carefull design make LIMBO II an exceptionally cleanaudio processor. Includes onboard controls for preemphasis selection (50uS,75uS or no preemphasis) and optional connector for LCD control unit, making itpossible to set all of the parameters via MENU system. RCA connectors (3-pinjumper for XLR balanced input) and 2.1mm power jack are mounted on the board soconnecting this unit requires no additional soldering. NOTE: If you have SE4 you don't need this unit as italready contains LIMBO II DSP. Have a quick look at the manual (LIMBO2) Havea quick look at the manual (LCD module) Features: - Freq. response:2OHz-15KHz (brickwall filtered)
- 19KHz notch, 70 Db typ.
- Audio InputImpedance: 600 Ohms, unbalanced or balanced
- Audio Input Level:0dB
- Distortion:<0.2% typically
- S/N ratio: <70dB
- Output Impedance:75 Ohms
- Output Level:0dB
- Power Requirements:7-15VDC / 150mA
- PC Board Size: 100x65mm (same as SE4)
- Audio connectors: all RCA jacks aremounted on the board
- Selectable preemphasis (50uS, 75uSor none)
LED control module makes itpossible to control: - Treble
- Bass
- Compression ratio and parameters
- Preemphasis
| 
