HL-150 (HF Amplifier, HF 1.5 - 30MHz)

This unit can be used with our AM MAX II DSP transmitters to increase output power up to 150W (250W pep SSB). We do not recommend pushing the unit too much unless extreme measures are taken as far as cooling is concerned. Additional fans are required for permanent operation as this unit was designed primarily for communication (where it cools at least 50% of the time).

Auto or manual microprocessor controlled band switching. 6 Low pass filter inside. LED band indicator. Bargraph LED output indicator. Auto TX/RX switching with SSB delay switch. Rear panel connection for external TX/RX switching. High SWR and over temperature protection.

Requires a suitable mains power supply: 13.8V/24A

Unit ships with instructions and schematic diagram for easy troubleshooting.
 
Technical specifications:
- Frequency: 1,5 - 30MHz.
- Supply: 12 - 14Vcc.
- Input energy: 24A.
- Input power: 1 - 10W (20W SSB).
- Output power: 150W Max (250W PEP).
- Mode: All.
- Output power level: 2.
- Size: 191 x 290 x66 mm.
- Weight: 1.9 Kgr.

For more pics check HL-300, units are almost identical.