|
AA-230 Antenna Analyzer
RigExpert AA-230 is a powerful antenna analyzer designed for testing, checking,
tuning or repairing antennas and antenna-feeder paths in 0.3 to 230 MHz range.
Graphical SWR (Standing Wave Ratio) and impedance display is a key feature of
this analyzer which significantly reduces time required to put an antenna to
rights.
Easy-to use measurement modes, as well as additional features such as memory
storage and connection to a personal computer, make it attractive for professionals
and hobbyists.
The new MultiSWR and SWR2Air modes are unique for this antenna analyzer.
The following tasks are well-accomplished by using RigExpert AA-230:
Rapid check-out of an antenna
Tuning an antenna to resonance
Comparing characteristics of an antenna before and after specific event (rain,
hurricane, etc.)
Making coaxial lines or measuring their length
Cable fault location
Measuring capacitance or inductance of reactive loads
Technical specifications:
Frequency range: 0.3
230 MHz
Display modes:
- SWR at single frequency
- SWR, R, X, Z, L, C at single frequency
- SWR graph
- R, X graph
Single- and multi-frequency measurement:
- Frequency resolution: 1 kHz
- SWR only mode: easily-readable bar
- SWR range: 1
10s
- SWR display for 50 and 75 Ohm systems
- R, X range: 0
1000, -1000
1000 Ohm
SWR and R, X graphs:
- 100 points plot
- Sweep width: 0.3
230 MHz
- Frequency resolution: 1 kHz
- SWR range: 1
10
- SWR display for 50 and 75 Ohm systems
- R, X range: 0
200, -200
200 Ohm
- 100 memories to store and recall graphs
- Presets for radio amateur bands
RF output:
- Connector type: UHF
- Power: typ. 10 dBm
Power:
- 4.8V, 1800 mAh, Ni-MH accumulator
- Max. 2 hours of continuous measurement
- Max. 2 days in stand-by mode
- External 9
14V, 200 mA charger
- Full charge time: 10
12 hours
Interface:
- 128x64 graphical LCD with backlit
- 6x3 keys on the water-proof keypad
- Multilingual menus and help screens
- USB connection to the personal computer
Dimensions: 23x10x5.5 cm (9x4x2)
Operating temperature: 0
40 °C (32
104 °F)
In the package:
- RigExpert AA-230
- Accumulators
- Soft case with straps
- Charger
- USB cable
- User's manual
- CD with drivers and software
AA-230 PRO specifications:
- Same as AA-230, with built-in TDR (Time Domain Reflectometer) mode which is
ideal for locating cable faults for example.
AA-500 Specifications:
- Same as AA-230, but extended to 1 to 500MHz frequency range, minimal sweep
range 100KHz, connector type = N female, output power = 5dBm, 10 bit A/D
AA-520 Specifications:
- Same as AA-230, but extended to 1 to 520MHz frequency range, minimal sweep
range 100KHz, connector type = N female, output power = 5dBm, 16 bit A/D
|